Rice Lake SURVIVOR LaserLight Series Remote Display - ConnexLink Wireless Radio 900 MHZ Installation User Manual
Page 4
Align hole in bracket to hole in
frame.
Install cord grip.
Reattach ground wire.
4
ConnexLink Option Installation Instructions
Figure 6. Attaching Radio/Bracket Assembly to Frame
10. Align large hole in bracket with the hole that the plastic plug was removed from.
11. Insert the cord grip through the bottom panel and the radio bracket. Cord grip should be loose.
12. Secure to bottom panel with the locknut and seal ring provided in the kit.
13. Reattach the ground wire using the 11/32 nut and the appropriate tool.
Install antenna through
cord grip and screw into
radio until snug.
Figure 7. Install Antenna
14. Insert the antenna into the cord grip and screw into the radio until snug.
15. Tighten the cord grip.
RF transceiver cable
assembly
Power-supply cable
assembly
Figure 8. Connect Cable Assemblies