Rice Lake SURVIVOR LaserLight Series Remote Display - ConnexLink Wireless Radio 900 MHZ Installation - Manual (Page 5)

ConnexLink Option Installation Instructions 5
16. Plug the power cord into the radio.
17. Install the 9-pin end of the remaining cable assembly into the radio, finger tighten the thumb screws.
18. The 6-pin end attaches to J8 on the CPU board.
19. Reassemble the body into the enclosure.
20. Connect radio marked "Server" to indicator being used, referencing the following diagram.
BLACK WIRE - DB9 - PIN 5 (GND)
GREEN WIRE - DB9 - PIN 3 (RXD)
WHITE WIRE - DB9 - PIN 2 (TXD)
ConnexLink
Tranciever
To Power Supply Outlet
(See Detail A)
(TXD)
(GND)
(RXD)
Indicator CPU Board
NOTE:
Power supply cable is only
routed out a cord grip when an
outlet is not available.
Drill and tap for four 6-32 screws
5600461 L
HUB
BE LL
N
F1
F2
-
-
-
Hot
Neutral
Ground
120VAC Power
Cord In
NOTE:
Detail A
DIN RAIL
Mount Connexlink radio in far lower right side of
back panel next to power supply utilizing the last
cord grip for the antenna.
RS-232
Note
See the indicator manual for further information.
Figure 9. Connect Radio to Indicator