3 raise mount into final position, 4 attach flexible conduit sections – Rice Lake SURVIVOR PT Series User Manual
Page 12
8
Survivor PT - Pit Type Truck Scale
3.3
Raise Mount into Final Position
1. Turn the leveling screws to raise the mount until the link is centered in the chair bearing and lightly
touching.
2. Level the plate in both directions. When the baseplate is directly under the chair, the link will be hanging
vertical when centered in the chair, see Figure 3-2. Approximately 1/4" of the link should protrude beyond
each side of the chair, seeFigure 3-3.
Figure 3-2. Final Mount Position
3. If adjustment is necessary, tap baseplate edges lightly with a hammer to slide the entire mount sideways
.
Figure 3-3. Load Cell Mount Parts
3.4
Attach Flexible Conduit Sections
A 30" section of flexible conduit (Figure 3-4) is included on each load cell.One end is threaded for mating with the
LB connector at the load cell. The other end adapts to 3/4" galvanized rigid conduit.
Figure 3-4. Flexible conduit.
Flexible conduit may also be plastic-coated metal (flex conduit).
UPPER CHAIR
LINK
1/4" PROTRUSION
LOAD CELL
LEVELING SCREW
BASEPLATE
1/2"
Note