Rice Lake Versa-portion, Rice Lake Weighing Systems - Manual (Page 7)

2 Versa-portion RLP-S/SM Operation Manual
2.0 Operation
2.1 On/Off
1.Press the
POWER
key. The display will blink
8.8.8.8.8.8.
and show
0.000
when ready
to weigh.
2.2 Tare
Tare values can be used for up to half of scale capacity.
Performing a Tare
1.Place the item to be tared (typically a container) on the platter.
2.Press the
TARE
key.
3.The display will show
0.000
with the tared item on the platter.
Removing a Stored Tare
1.Remove the tared item from the platter.
2.Press the
TARE
key.
3.The display will show
0.000
.
2.3 Automatic Shut-Off Timer
The Versa-portion RLP-S/SM has a built-in automatic shut-off timer. This timer can be set
to turn the unit off after three minutes of inactivity or 10 minutes of inactivity.
Setting the Timer for Three Minutes
1.If the unit is powered on, press the
POWER
key until it shuts down.
2.With the unit powered off, press and hold the
POWER
key for three seconds. 
The display will show
3
.
3.Release the
POWER
key. The timer is now set to turn the unit off after three minutes of
inactivity.
Setting the Timer for 10 Minutes
1.If the unit is powered on, press the
POWER
key until it powers off.
2.With the unit powered off, press and hold the
POWER
key for six seconds. 
The display will show
3
after a period of three seconds. It will show
10
after six
seconds.
3.Once the display shows
10
, release the
POWER
key. The timer is now set to turn the
unit off after 10 minutes of inactivity.
Disabling the Timer
1.If the unit is powered on, press the
POWER
key until it shuts down.
2.With the unit powered off, press and hold the
POWER
key for nine seconds. 
The display will show
3
after a period of three seconds and
6
after six seconds. It will
show
999
after nine seconds.
3.Once the display shows
999
, release the
POWER
key. The timer is now disabled.
2.4 Display Brightness
The Versa-portion RLP-S/SM display brightness can be set to one of three levels.
Changing the brightness setting
1.Hold the
ZERO
key and press
Tare
three times.
2.Press the
ZERO
key to increase the dimmer level and the
Power
button to decrease the
dimmer level.
3.The display will show
1
,
2
,
3
, or
4
depending on which dimmer level is being
displayed.
4.Press the
TARE
key to save the setting and return to weigh mode.