Sage Barista Express BES870UK - Manual (Page 27)

26
CarE & ClEanIng
ClEanIng tHE ConICal BUrr grIndEr
This grinder cleaning cycle removes oil build-up on the burrs which can impede performance.
adVanCEd ClEanIng for tHE ConICal BUrr grIndEr
This step is only required if there’s a blockage between the grinding burrs and the grinder outlet.
Empty hopper Replace hopper Lock hopper Run grinder empty Unlock hopper Unlock hopper
1 2 3 4 5
SINGLE DOUBLE
PUSH
6
Remove top burr Clean burr with brush Clean lower burr with
cleaning brush Clean chute with brush Unlock top burr
8 9 10 11 12
LOCK
ALI
GN
SINGLE DOUBLE
PUSH TO GRIND
Remove hopper
7
POWER FILTER SIZE GRIND AMOUNT POWER FILTER SIZE GRIND AMOUNT
Set 'GRIND SIZE' to '1'
(finest) Use 10mm socket. Rotate
'Clockwise' to remove nut Set 'GRIND SIZE' to '16'
(coarsest) Remove top burr Remove lower burr Remove hopper
1 2 3 4 5 6
Clean chute with brush Insert grind fan & washers
using long nose pliers Insert Lower Burr (drive pin
& cavity in burr to align) Rotate 'Anti-clockwise' to
tighten nut Unblock the grinds exit
chute using the cleaning
brush or a pipe cleaner
8 9 10 11 12
Insert top burr
13
Set 'GRIND SIZE' to '5'.
Insert hopper
14
SINGLE DOUBLE
PUSH TO GRIND
Remove grind fan & washers
using long nose pliers
7
POWER FILTER SIZE GRIND AMOUNT
GRIND SIZE
LOOSEN NUT
TIGHTEN NUT
GRIND SIZE
GRIND SIZE
1. GRIND FAN
2. METAL WASHER
3. FELT WASHER
3
2
1
1. FELT WASHER
2. METAL WASHER
3. GRIND FAN
1
2
3
WARNING
Care should be taken as the
grinder burrs are extremely sharp.