Smart Power Systems HR-30 (3-Phase) - Manual (Page 29)

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 28 of 52
Enabling Auto-Start Option
a. If the Command & Control Center is dark, press the Mode switch to put the
Command & Control Center into Normal mode.
b. Press and hold the Mode switch until the Amps Line 1 field begins blinking
88
(more than 10 seconds). Release the switch so
0Pt and AStr appear.
Reference Figure 15.
c. Press the On/Off switch until the desired value appears. A
y means Auto-Start
is enabled, an n means Auto-Start is disabled.
d. Return to Normal mode by pressing Mode.