Char-Griller 5050 - Manual (Page 13)

Step 9
Install the BURNERS into the GAS GRILL BODY by first inserting the open end of the BURNERS
through the holes directly behind the CONTROL PANEL and then onto the VALVE tip. Make sure
the valve tip is completely inside the hole on the end of the BURNER. Install the BURNER with
the long wire on the right side of the GAS GRILL BODY
. Secure the other end of the BURNER
to the GAS GRILL BODY with the SCREW provided. Again, make sure the VALVE tip is completely
inside the hole on the end of the BURNER. Now, completely tighten the CONTROL PANEL making
sure the Valve tip stays inside the burner tube.
Burner
Valve
Step 10
Insert the IGNITER WIRES, which are attached to the underside of each BURNER, through
the same hole in the GRILL BODY that the BURNER goes through and then attach the WIRE
to the backside of the ELECTRONIC IGNITER, which is attached to the back side of the
CONTROL PANEL.
Any wire can go into any of the three sockets on the Electronic Igniter.
Igniter Wire Electronic Igniter
Burner
Step 11
Install the CONDIMENT BASKET to the CHARCOAL GRILL BODY using four (4) LOCK
WASHERS and four (4) ½” BOLTS. From inside the GRILL BODY the BOLTS go through a
LOCK WASHER and then through the GRILL BODY and then screw into the CONDIMENT
BASKET.
BASKET.
Condiment Basket
Bolts and Lock Washers
page 13
™ & © 2006 Char-Griller / A&J Mfg.
Condiment Basket