ThingMagic Universal Reader Assistant 2.6 - Manual (Page 14)

Connect
Universal Reader Assistant v2.6 User Guide 14
Save Profile
Once connected to a reader, with it working as desired, the full configuration of the reader,
including the reader connected to, all read options, performance settings and display
settings can be saved to a URAC (URA Config) file by following these simple steps:
1. Click “Save”
2. File manager pops up in URA.exe directory. The default filename field populated
with [reader type]_[readername].urac. This maybe changed as desired.
3. Click “Save” in the file manager to save to the specified file.
Load Profile - Before Reader Connect
If you have not yet connected to a reader and want to load a previously saved profile and
connect to the same reader the profile was saved from the Load operation will both
connect to the reader and load the saved profile:
1. With URA Status indicator showing [Red] Disconnected, click “Load”.
2. Select desired *.urac file and “Load”.
3. Load attempts to connect to the Reader URI saved as part of the profile.
4. If the connect fails an error will be displayed and the Load Profile - After Reader
is already connected workflow should be followed.
5. If connect succeeds the full saved profile and display options are loaded.
Load Profile - After Reader is already connected
If you want to load a previously saved profile onto a different reader than it was saved
from you must first connect to the reader then load:
1. With URA Status indicator showing [Yellow]] Connected, click “Load”.
2. Select desired *.urac file and “Load”.
3. Since already connected Load ignores reader URI and only loads the profile.
4. The full saved profile and display options are loaded.