Torbal AGCN200 - Manual (Page 8)

Instruction Manual - TORBAL AGCN Series
Chapter 6.
UNPACKING THE BALANCE AND GETTING STARTED
1. Carefully remove the scale, pan, and all of its components out of the packaging and place them on a stable
base where the scale will not be affected by any mechanical vibrations or air movements.
2. After removing the chamber base (4), draft ring (3), pan base (2), and the pan (1) from their packaging,
carefully install the chamber base (4) on the case of the balance as shown below. Once the chamber base is in
place, install the draft ring (3). Once components 4 and 3 are in place install the pan base onto the scale by
placing it on the pan support located in the middle of the scale. Once the pan base has been installed, carefully
place the pan on the base as shown below.
8
7
6
1 2
3
4