CITIZEN PPU-231 - Manual (Page 37)

PPU-231 User’s Manual
24 CITIZEN
5. DIP SWITCH SETTING
5.1 Location of DIP Switch
The following figure clearly shows where the DIP switches are.
Any settings made while the power is turned on will not take effect. Turn the power on after you set the
DIP switches.
1. Turn off the power.
2. Remove the DIP switch cover screw. (Be careful not to lose the screw.)
3. Slide the cover towards you and lift it to remove (see arrows in the figure).
4. Set the DIP switches.
5. After you have made the required settings, reattach the cover and screw.
CAUTION:
1) The DIP switch cover has sharp edges. Be careful not cut your fingers.
2) The screw is an M 2x3mm type. Do not use any other type. If you do lose it, replace it with the same type.
Do not use screws that are longer than 3mm.
3) Always turn off the power before setting. If you make settings while the power is on, the unit may become
faulty.
4) Do not use anything sharp and pointy to set the DIP switches.
5) Always set the switches that have been specified as disabled to OFF (the setting that existed when shipped).
6) Do not use the unit while the DIP switch cover is removed.
Dip Switches