Welch Allyn Acuity and Mobile Acuity LT Central Monitoring Systems - User Manual User Manual
Page 110
106
Chapter 6 Review or print patient data
Welch Allyn Acuity Central Monitoring System
To locate and display alarm and event information
1.
Along the top of the waveforms, click an event marker.
•
▼ event markers show Relearn, Learning Done or Snapshot Print events.
•
♥
event markers show that an arrhythmia alarm was recorded.
•
♥
event markers show that an arrhythmia event was detected, but no alarm
occurred because alarming for this arrhythmia type was turned off in the
Arrhythmia Alarms Setup window.
The blue cursor bar identifies event types along each waveform.
2.
Jump to the next or previous alarm or arrhythmia event.
•
Click
or
to jump to the next or previous alarm.
•
Click
or
to jump to the next or previous arrhythmia event.
3.
Jump to the next or previous event of the same type that is currently displayed.
•
Click
or
to jump to the next or previous alarm of the same type.
•
Click
or
to jump to the next or previous arrhythmia event of the same
type.
The blue cursor bar identifies the event.
If you do not see some of these buttons in the window, click
or
in the upper
left corner of the Acuity System screen to change the screen view.
Cursor bar