Welch Allyn Service Tool, Installation and Configuration - Installation Guide - Manual (Page 10)

Welch Allyn Service Tool 7 Chapter 2 Installation
Installation continued: USB driver
The Setup program automatically starts the USB driver installation,
and the Welcome screen appears.
1. Click Next. The Custom Setup screen appears.
2. Identify where you want to install the driver and click Next. The
default location is as follows:
{ProgramDirectory}\Common Files\Welch Allyn\Drivers\
3. Click Next. Setup displays the settings you selected, providing an
opportunity to ensure that the settings are correct before
proceeding.
4. Click Next. Setup copies and installs the files you selected. The
InstallShield Wizard Completed screen then appears.
5. Click Finish. USB driver installation is now complete.
Installation continued: PartnerConnect
®
(Gateway Agent)
The Setup program automatically starts the RSDS installation, and
the Welcome screen appears.
1. Click Next. The License Agreement screen appears.
2. Accept the license agreement, and click Next.
The Site Information screen appears.
Note Your default {ProgramDirectory} location may differ.