Zippy GSM-7450P - Manual (Page 21)

– – HG2, HP2, GSM and PSL Ver. 2.0
- 21 -
Specifications
Please refer to the specifications according to the actual product purchased.
INPUT CHARACTERISTICS: HP2-6460P/6500P(G1)
VOLTAGE: 90 ~ 264 VAC FULL RANGE.
FREQUENCY: 47 ~ 63 Hz.
INPUT CURRENT: 7.5/8.0 A FOR 115 VAC, 3.5/4.0 A FOR 230 VAC.
INRUSH CURRENT: 65 A MAX. FOR 115 VAC, 125 A MAX. FOR 230 VAC.
OUTPUT CHARACTERISTICS:
LOAD LINE
RIPPLE & NOISE
MAX.[P-P]
5V 5% 1% 60mV
12V 5% 1% 100mV
5% 1% 100mV
5% 1% 100mV
3.3V 5% 1% 60mV
+5VSB 5% 1% 60mV
REMARK: TOTAL OUTPUT SHOULD NOT EXCEED 460W/500W FOR HP2-6460P/6500P.
*** WHEN PERFORMING CROSS REGULATION TEST, IT IS REQUESTED TO SET THE HIGHER OUTPUT
CHANNEL AT 90% MAXIMUM AND THE LOWER OUTPUT CHANNELS AT 20% MININUM OF RATED
SPEC.
TEMPERATURE RANGE: OPERATING 0
0
C --- 40
0
C, STORAGE –20
0
C --- 70
0
C.
HUMIDITY: 10 ~ 90 % RH.
HOLD UP TIME: 16 ms MINIMUM AT FULL LOAD & 90 VAC INPUT VOLTAGE.
DIELECTRIC WITHSTANDING VOLTAGE:
PRIMARY TO SECONDARY : 1800VAC FOR 60 SEC.
PRIMARY TO FG : 1800VAC FOR 60 SEC.
EFFICIENCY: 71% TYPICAL, AT FULL LOAD, 115VAC.
POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms, OFF DELAY 1 ms
OVER LOAD PROTECTION: 110 ~ 150% MAX.
OVER CURRENT PROTECTION:
+5V 44 A ~ 60 A, + 3.3V 33 A ~ 45 A, 12V 35.2 A ~ 48.0 A.
OVER VOLTAGE PROTECTION:
+5V
5.7V ~ 6.5V, 3.3V 3.9V ~ 4.3V, 12V 13.6V ~ 15V.
EMI: MEET FCC CLASS B, CISPR22 CLASS B.
SAFETY: UL 60950, CSA 1402C & CSA 950, TUV EN-60950.
ACTIVE POWER FACTOR CORRECTION MEET IEC-1000-3-2 CLASS D
REMOTE ON / OFF CONTROL.
SHORT CIRCUIT PROTECTION: SHUTDOWN AND LATCH.
BUILT-IN ACTIVE POWER FACTOR CORRECTOR.
COOLING: ONE 80 mm DC BALL BEARING FAN.
DIMENSION: 86(H) X 150(W) X 140 (D) mm (PS/2).