Zippy GSM-7450P - Manual (Page 7)

– – HG2, HP2, GSM and PSL Ver. 2.0
- 7 -
INPUT CHARACTERISTICS: HG2-6400P(G1)
VOLTAGE: 90 ~ 240 VAC FULL RANGE.
FREQUENCY: 47 ~ 63 HZ.
INPUT CURRENT: 8.0 A (RMS) FOR 115VAC, 4.0 A (RMS) FOR 230VAC.
INRUSH CURRENT: 65A MAX. FOR 115 VAC, 125A MAX. FOR 230 VAC.
OUTPUT CHARACTERISTICS:
LOAD LINE
RIPPLE & NOISE
MAX.[P-P]
5V 5% 1% 50mV
12V 5% 1% 120mV
5% 1% 150mV
5% 1% 150mV
3.3V 5% 1% 50mV
+5VSB 5% 1% 50mV
REMARK: OUTPUT CURRENT OF +5V & +3.3V COMBINED SHOULD NOT EXCEED 45A.
SPECIFICATION:
TEMPERATURE RANGE: OPERATING -10 --- 45
HOLD UP TIME: 16 ms MINIMUM AT FULL LOAD & NORMAL INPUT VOLTAGE.
DIELECTRIC WITHSTANDING VOLTAGE:
PRIMARY TO SECONDARY : 3000VAC FOR 1 MIN.
PRIMARY TO FG : 2200VAC FOR 1 MIN.
EFFICIENCY: 70% TYPICAL.
POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms, OFF DELAY 1 ms.
OVER LOAD PROTECTION: 130 +/- 20%.
OVER VOLTAGE PROTECTION:
+5V
5.7V ~ 6.5V, 3.3V 3.9V~ 4.3V, 12V 13.6V ~ 15V.
SHORT CIRCUIT PROTECTION: +5V, -5V, +12V, -12V, +3.3V.
EMI NOISE FILTER: FCC CLASS B, CISPR22 CLASS B.
SAFETY: MEET UL 60950, CSA C 22.2 NO. 60950, TUV EN-60950,
CCC GB4943-1995/GB9254-1998/GB17625.1-1998
ACTIVE POWER FACTOR CORRECTION MEET IEC-1000-3-2 CLASS D
REMOTE ON / OFF CONTROL.
THE UNIT SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE / ENABLE
ALL OUTPUT VOLTAGES (EXCLUDE +5V STANDBY),
AS LOGIC LEVEL IS LOW, OUTPUT VOLTAGES WERE ENABLE,
AS LOGIC LEVEL IS HIGH, OUTPUT VOLTAGES WERE DISABLE
ADVANCED THERMAL & ACOUSTICS CONTROL FEATURES..
3.3V / 5V REMOTE SENSING.
COOLING: ONE 80mm DC BALL BEARING FAN.
DIMENSION: 140 (D) x150 (W) x 86 (H) mm (PS/2).