Panasonic CQDFX555 - Manual (Page 35)

Anti-Theft System
continued
Warning Alarm
Caution
This car radio is equipped with an integrated Warning Alarm in order to make robbery more difficult.
But it has to be secured that the installation will be properly done so that the Warning Alarm may
work in a perfect way. Concerning the installation the following points have to be observed:
1. The supplied mounting collar has to be firmly fixed with the mounting tabs to the
dashboard.
2. The radio has to be put into the mounting collar in that way that it exactly ends with
the collar.
3. Please make sure that the technical features (impedance and power) of the speakers
installed correspond to the specifications of this car radio (see technical specifica­
tions).
Only when these three points are observed during the installation, the correct function of the
“Warning Alarm” will be secured.
If the main unit is not correctly wired and installed, the system may accidentally sound the alarm.
Warning Alarm and Security indicator
The security indicator blinks when the removable face plate is removed from the unit. Furthermore, the alarm
will set off for 1 minute then reset when an attempt is made to remove the unit from the mounting collar.
Activate Warning Aiarm and Security indicator
1. Press and hold SEL for more than 4 seconds when the power is ON. “ALRM ON” is displayed, and the
security indicator and Warning Alarm turn ON.
Note: The ALARM mode is inactivated when it is shipped.
2. To check whether the unit is set in the ALARM ON mode, make sure that the security indicator blinks when
the removable face plate is removed.
______Display______ Security Indicator Warning Alarm Panel Removal Alarm
ON
I IIV/I I l l V i
KM u K(
Blinks ON
tt
I n L<iv/(
I ( L I \ I I
Caution:
(Press and hold SEL for more than 4 seconds.)
OFF OFF OFF
Warning Alarm system may not operate If the exclusive supplied mounting collar Is not used. This mount­
ing collar will set off the alarm when the unit is being removed.
If the main unit is not correctly wired and installed, the system may accidentally sound the alarm.
When removing or installing the unit, make sure that it is in the ALARM OFF mode.
When the Warning Alarm is activated by mistake, or when you want to remove the unit, the Warning Alarm
and the security indicator functions can be canceled by the following steps of procedure.
• Install the removable face plate.
• Disconnect the power connector.
Panel Removal Alarm
This alarm sounds to warn you not to forget to remove the panel before leaving your car. This function is acti­
vated when the security alarm is ON.
CQ-DFX555/DFX355LEN
35