Panasonic CQDFX555 - Manual (Page 36)

Installation
Preparation
• Before installation check the radio operation with antenna and speakers.
• Disconnect the cable from the negative (-) battery terminal (see caution below).
Caution:
For installation to cars with trip or navigational computers, all electronic memory settings previously registered
in the computer will be lost when the battery terminal is disconnected. For this type of car, battery could not be
disconnected. Therefore, extra care should be taken to prevent short circuitting.
In-dash Installation
Installation Opening
in-dash installation can be done if the car’s dash­
board has an opening for this unit as shown in Fig.
1. The car’s dashboard should have a thickness of
4.5mm - 6mm in order to make the installation of
the unit.
-182 mm-
Fig.1
T
53 mm
JL
installation Precautions
This equipment, if possible, should be installed by a professional installer.
in case of difficulty^ please consult your nearest authorized Panasonic Service Center.
1. This system is to be used only in a 12-volt, DC battery system (car) with negative ground.
2. Follow the electrical connection on page 39 carefully. Failure to do so may result in damage to the unit.
3. Connect the power lead after other connections are made.
4. Be sure to connect the YELLOW lead to the positive terminal (+) of the battery or fuse block (BAT) terminal.
5. insulate all exposed wires to prevent short circuitting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation instructions of the respective equipment before connect­
ing ittothis unit.
Supplied Hardwares
No. Item Diagram Q'ty
© Mounting Collar 1
Mounting Bolt (5 mmo) ^
^ -
1
' (D Power Connector 1
©
Removable Face Plate
Case
1
Nn 1III
.
“-v
1 Remote Control Unit
' . .
B
1
Trim Plate 1
©
Lithium Battery 1
® ISO Antena Adaptor 1
36
CQ-DFX555/DFX355LEN