Speaker connections – Panasonic CQDFX555 User Manual
Page 40
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Speaker Connections
2 Tnc speaker'^ to be used v. th :n ь и"!; shojlc be able to handle more »hj" ¿OW of audio power. If an
optronal amplifier is used, the speakers should be able to handle the maximum output power of the
amplifier Use o‘ speake'i- '.мт small .nout ratings can cause damage *c tiir soeate's
3.
The speaker impedance should be 4 - 8 ohms. If the impedance is too large or too small, it affects the
output and may cause damage to the speakers or this unit.
'■ Co so: use 3-w‘re type ьDea^c' lyutem having a common earth Icac Neve'- connect the spea<er cord
to the body of the car. This unit uses the BTCL circuit, so each speaker should be connected separate
ly using parallel vinyl insulated cords
5 The spea^er cords and the роле' ar-oiif'C jn,t s'^ould be kept away 'about 30cm apahi ‘ram the
antenna and antenna extension cord.
6 Follow the connection diagram below carefully. Failure to do so may cause damage to both unit and
• Unit will be damaged if speakers (Front, Rear) are not connected properiy.
L*
AV |1лМй-.1. Г|.г:
RIGHT
R*
White
w/Black Stripy
—gray
^
Gray _
WRONG
l
:
T,
L"
r
!
Chassis,^
rir
WRONG
R"
rr1
LkJ
Chassis
• Do not connect more than one speaker to one set of speaker ieads.
RIGHT
L"
White p|X
White
w/Black Stripe^
Grav
R*
Gray
WRONG
: 1
40
CQ-DFX555/DFX355LEN