Crestron electronic DIN-PWS50 - Manual (Page 13)

Crestron DIN-PWS50 DIN Rail 50 Watt Cresnet
®
Power Supply
The DIN-PWS50 is designed for installation on a DIN rail. Refer to the
following diagram when installing.
Installing the DIN-PWS50
DIN-PWS50
DIN RAIL RELEASE
DIN RAIL
(NOT SUPPLIED)
TOP
1. Place the top of the DIN-PWS50’s rail mount over the top of the
DIN rail.
2. Tilt the bottom of the DIN-PWS50 toward the DIN rail until it
snaps into place.
NOTE: When mounting DIN rail products, it may be necessary to
use a flat-head screwdriver to pull the DIN rail release tab while
snapping the device onto the DIN rail.
To remove the DIN-PWS50 from the DIN rail, use a small, flat object
(i.e. a flat-head screwdriver) to pull the DIN rail release and tilt the
bottom of the DIN-PWS50 away from the DIN rail.
NOTE: Certain third party DIN cabinets provide space for an
informational label between each DIN rail row. Crestron’s Engraver
software (version 4.0 or later) can generate appropriate labels for all
Crestron DIN rail products.
Operations & Installation Guide – DOC. 6667A DIN Rail Power Supply: DIN-PWS50 • 9