Crestron electronic DIN-PWS50 - Manual (Page 16)

DIN Rail 50 Watt Cresnet
®
Power Supply Crestron DIN-PWS50
Fuse
Replacement If the DIN-PWS50 does not power up when it is plugged into an AC
outlet, the fuse may need to be replaced. The fuse holder is located on the
front panel, under the cover in the lower left corner. To replace the fuse:
1. Disconnect power to the DIN-PWS50.
2. Remove the cover from the lower left corner on the front of the
DIN-PWS50.
3. Remove the defective fuse from the fuse holder and replace with a
new one.
CAUTION: Use only time lag type fuses, 3.15 Amps / 250 Volts.
Failure to do so may cause damage to the DIN-PWS50.
4. Replace the fuse cover.
5. Connect power to the DIN-PWS50.
12 • DIN Rail Power Supply: DIN-PWS50 Operations & Installation Guide – DOC. 6667A