B&C Technologies HP Series Commercial - Manual (Page 7)

Before Initial start up of a B&C washer
extractor perform the following safety check:
A. Make sure all electrical and plumbing
connections have been made in
accordance with applicable codes and
regulations.
B. Make sure the machine is grounded
electrically.
C. Make sure the machine has flexible
water fill and drain connections of the
correct size, length and type, with no kinks,
and that they are securely attached and/or
clamped.
Before machine is placed in operation,
the
door safety interlock must be checked for
proper operation as follows:
A. When the washer is energized
electrically and in operation, the loading
door must be locked in the closed position.
Verify this by attempting to open the
loading door when the machine is
operating. If necessary, check the door
safety interlock and sensors for proper
operation. Consult the service manual, or
call a qualified service technician if
necessary.
B. When the washers loading door is
open, it should not be possible to
start the machine. Verify this by attempting
to start the washer with the door open. Also,
close the door without locking it and verify
that it is not possible to start the machine
with the door not locked. If necessary,
check the door lock sensors for proper
operation,. Consult the service manual, or
Introduction
Safety Checklist
call a qualified service technician. If
additional information is required, contact
your local distributor or call the
manufacturer of the machine.
Before servicing any equipment, make
certain it is disconnected from the electrical
power source. Never allow
operation of the machine
when any safety device is
malfunctioning. Never
bypass safety devices.
6