B&C Technologies IP Series Commercial Ironer - Manual (Page 23)

Basic Troubleshooting
Procedure
23
Temperature Control shows
Temperature Control shows
Temperature Control shows
Ironer will not start or stops suddenly
Ironer makes unusual noises
O-E
S-E
Err
Indicates an open circuit
- check cable
connections at the temperature controller
and the probe wiring for damage.
Indicates a short circuit in the temperature
probe wiring circuit - check the probe cable
for damage.
Damaged sensor. Replace.
-Make sure the Emergency Stop button
isn’t pressed.
-Check the hand/finger guard.
-Check that all panels are in place and
attached.
If the ironer makes unusual noises (rubbing,
grinding, banging, etc.) properly shutdown
the machine and contact a qualified service
technician.
in the temperature
probe wiring circuit