B&C Technologies B-Computer Programming (HE Series) - Manual (Page 12)

Programming
Cycle Programming (continued)
When modifying a cycle time, a time must be
entered for each segment. To skip a segment or
spin, enter 00 for the time and press the Start
key. The following table shows the range of
time allowed for each segment and spins, as
well as the allowed temperature range for
machines equipped with auxiliary heat.
Note that spin times are programmed in
seconds for intermediate spins following
Prewash, Wash, and Fills 1 through 5. The
final spin, following Fill 6 is programmed in
minutes.
To begin programming, press the Up key shows
the segment to be edited, then press the Start
key.
For the Prewash segment, you can select either
PREU (normal Prewash) or FLUS (overflow fill
Prewash). If Overflow Prewash is selected, the
fill valves will remain on for the duration of the
Prewash step. Press the Start key to make your
selection.
If the Spray Rinse option is enable in Setup,
you have the option of Spray Rinse or Dilution
Rinse during Fill 1 through Fill 5. The display
shows SRIN for spray rinse or dRIN for dilution
rinse.
Func tion Minimum Maximum
Prewash 2 minutes 30 minutes
Wash 2 minutes 20 minutes
Fill 1 2 minutes 15 minutes
Fill 2 2 minutes 15 minutes
Fill 3 2 minutes 15 minutes
Fill 4 2 minutes 15 minutes
Fill 5 2 minutes 15 minutes
Fill 6 2 minutes 15 minutes
Intermediate Spin 30 seconds 120 seconds
Final Spin 1 minute 10 minutes
Temperature 75F / 25C 200F / 93C
Time and Temperature Parameters
Display Fill Type
HFIL Hot Fill
CFIL Cold Fill
BFIL Warm Fill
Fil l Temperature Options
After you have selected the appropriate fill
temperature, press the Start key.
Now you can select the Fill level by using the
Up or Down key. Select your fill level
according to the following table.
Display Fill Level
LOLE Low Level
HILE High Level
Fil l Level Options
Note that if you selected FLUS for the Prewash
segment, this selection is skipped. After your
Fill level selection, press the Start Key.
Next select the desired Supply option. See the
table.
11
Display Supply
SUP0 No Supply
SUP1 Supply 1
SUP2 Supply 2
SUP3 Supply 3
SUP4 Supply 4
SUP5 Supply 1 & 2
SUP6 Supply 2 & 3
SUP7 Suppply 3 &4
S uppl y Options
Supply 4 & 7 are only
avaliable if is Supply 4 was
enabled in Setup
Use the Up and Down keys to select the fill
temperature. The following table shows the
available options.