B&C Technologies B-Computer Programming (HE Series) - Manual (Page 7)

Display Meaning Display Meaning
S04 ROM code. Example only. FLUS Overflow prewash selected
Hold Wait - machine just powered up CFIL Cold Fill
CY Cycle number (followed by 2 digits) Bfil Warm Fill (both hot and cold)
CHEC / CYC Test Cycle hfil Hot Fill
Far Degrees Farenheit lole Low water level
CEL Degrees Celcius hile High water level
PrE Prewash segment (1st of 8 segments) sup1 Supply 1
UASH Wash segment (2nd of 8 segments) sup2 Supply 2
FIL1 First rinse (3rd of 8 segments) sup3 Supply 3
FIL2 Second Rinse (4th of 8 segments) sup4 Supply 4
FIL3 Third Rinse (5th of 8 segments) sup5 Supply 5 (Supply 1 & 2)
FIL4 Fourth Rinse (6th of 8 segments) sup6 Supply 6 (Supply 2 & 3)
FIL5 Fifth Rinse (7th of 8 segments) sup7 Supply 7 (Supply 3 & 4)
FIL6 Sixth Rinse (8th of 8 segments) stop Stop Routine
SRIN Spray Rinse sdly Spin coast down delay
DRIN Dilution Rinse done Cycle complete, open the door
PrEU Normal Prewash selected door Door not closed and locked
SPIn / rInE
Reads "spin" for one second, then "time"
followed by the spin time
fill / stop
Programmed water level not reached
after 30 minutes
Tsfl
Temperature sensor failure or
temperature out of range.
full
Water level is detected when none
should be present. Can indicate a
clogged drain.
Operation
Cycle Selection
Press the up or down key until the desired cycle
number is showing on the display. Press the
keys just hard enough to activate them.
Pressing harder will cause undue wear on the
keypad. After you arrive at the desired cycle,
ensure the goods are loaded, and the door is
closed. Then press Start. If the door is not
properly closed and locked, the display will
read Door until the door is properly closed and
locked. After the door is closed, press start.
Cycle Execution
A cycle can be aborted at any time by pressing
the stop key. The machine will enter the stop
routine after which the door may be unlocked
(display reads done).
To display the temperature of the wash solution
during a cycle, press the up key. To display the
cycle number currently in process, press the
start key.
Display Indications
The following table lists the displays the B-compter is capable of and their meanings. Familiarize
yourself with these displays and their meanings.
6