B&C Technologies B-Computer Programming (HE Series) - Manual (Page 13)

Programming
Cycle Programming (continued)
After selecting your desired supply option, press
the Start key.
If your machine is equipped with Auxiliary
heating, and it was enabled during Setup
programming, you may use the up or down key
to select the target temperature for the segment.
To disable Auxiliary heat for the segment, set
the value to zero.
NOTE
If the machine does not have auxiliary
heating, do not program a temperature.
If you program a target temperature that
the machine is unable to achieve, the
machine will try for 30 minutes during
the segment. It is also important not to
program heat during a prewash segment
with a flush fill.
After you have selected the temperature, press
the Start key.
Now select the spin time for the segment. If
you wish to skip the spin, set the value to zero.
NOTE
If the machine does not have auxiliary
heating, do not program a temperature.
If you program a target temperature that
the machine is unable to achieve, the
machine will try for 30 minutes during
the segment. It is also important not to
program heat during a prewash segment
with a flush fill.
Details
Use Up or Down to change. Start key is enter or advance
PRE or FLUS Select Regular prewash or Flush
00 or 02 - 30 Segment time: 00 to skip, or any time between 0 and 30 minutes
HFIL CFIL BFIL Fill temperature: Hot, Cold, or Warm (both fill)
SUP0 - SUP7 Select Supply 0-7 (0 for no supply during the step)
00, 75 - 200
00, 25 - 93
SPIN flases for 1 sec
TIME flases for 1 sec
00 or 30 - 120
Select time for spin: 30 - 120 seconds. 00 for no spin.
Note: Supply 4 and 7 are only availble if enabled in Setup
Note: Heat is only available if enabled in Setup
Prewash Segment
Display
PRE
Enter temperature: 75-200 deg F, 25-93 deg C. 00 for no heat.
Select 00 if you have programmed a Flushing Prewash
Cycle Segment Charts
12
After you have set the spin time, press the Start
key, The display will now show the name of
the next program segment. See the chart on
page 10 for the list of program segments and
what the display indicates for each.