B&C Technologies M720 Dryer Control (DE, DP, DI Series) - Manual (Page 29)

Changing the character where the cursor is on can be done with the numeric keypad, in more or
less the same way text messages are created on cell-phones. See Table 4.2 on page 26 and Figure
4.3 on page 27 for details.
Table 4.2: M720 Program Naming Key Functions
key Character Sequence
1 , . / ( ) o 1
2 a b c A B C 2
3 d e f D E F 3
4 g h i G H I 4
5 j k l J K L 5
6 m n o M N O 6
7 p q r s P Q R S 7
8 t u v T U V 8
9 w x y z W X Y Z 9
0 0 [SPACE]
4.5.3 Edit Machine Parameters
The machine parameter list is a list with parameters which can be programmed to set-up general
parameters in the machine. These parameters are used for all programs. Because they are valid
for all programs, machine parameters are only accessible via the level 2 password.
In the edit machine parameters screen, parameters can be selected with the A RROW U P and A R -
ROW D OWN keys. A value can be changed with the P LUS and M INUS keys, or with the numeric
keys. Changing the value must be confirmed with the E NTER key. The upper line will show the
number and name of the parameter, followed by the value.
On the lower line, the maximum and minimum limit will be displayed. If the icon is shown, it is
possible to move up or down in the list, if the icon is shown it is possible to increase or decrease
the value. If the S HIFT key is used in combination with the arrow keys, the controller will move to
the first or last item in the list. If the S HIFT key is used in combination with the P LUS and M INUS
keys, the value will be increased or decreased in larger steps. Refer to Figure 4.4 on page 28 for
more details.
The following machine parameters are available:
26