Chapter 10 troubleshooting – Canon SCANFRONT 300P User Manual
Page 178
10-7
Chapter 10 Troubleshooting
Password is incorrect.
Cause
The password that was entered is incorrect.
Solution
Enter the uppercase and lowercase letters for the password correctly.
There is no file name specified.
Enter a file name or enable the
‘Auto file name’ setting.
Cause
A file name was not entered and “Auto file name” is set to [None].
Solution
Enter a file name or set “Auto file name” to other than [None].
Log in failed. Settings may
currently be in the process of
being edited via the Web.
Cause
User settings are being edited via the Web menu.
Solution
Contact the administrator of the ScanFront.
Log in failed. A version upgrade
may currently be in the process
of being executed.
Cause
The version of the ScanFront is being updated via the Web menu.
Solution
Contact the administrator of the ScanFront.
Cannot write logfile. Sending
files will be aborted.
Cause
Write permission has not been granted for the shared folder specified as
the save destination of the log file.
Solution
Check the settings and access permissions of the shared folder.
You can’t use following
character for File name.
Cause
Invalid characters have been used to set the customer file name.
Solution
Make sure the custom file name does not contain any of the following
characters:
/ : ? * " < > |
The character string includes
invalid character.
Cause
Invalid characters have been used to set the index file.
Solution
Make sure none of the following characters are used in strings
contained in the index file:
& " ' < >
Not enough memory to execute
current scanner settings. Please
see “Troubleshooting” section at
“INSTRUCTIONS” or “Operating
Guide”.
Cause
There was not enough memory available for the set scanning
conditions.
Solution
Reset the scanning conditions. Refer to “Not enough memory to
execute scanner settings” below.
Log in failed. A version
Password may be changed.
Cause
User password was changed on the authentication server while server
authentication and fingerprint authentication are both used to log in.
Solution
Without using fingerprint authentication, enter your user name and
changed password to log in, and then re-register your fingerprints.
Log in failed. Authentication
server is not found.
Cause
The user specified when logging in does not exist in the authentication
server.
Solution
Make sure you correctly enter your user name and password. Contact
the administrator of the ScanFront if this problem persists.