M2TECH Young DSD - Manual (Page 24)

YOUNG DSD
DIGITAL-TO-ANALOG CONVERTER AND PREAMPLIFIER
REVISION 1.1 – march 2014
Copyright © 2014, M2Tech Srl
24
M2Tech
www.m2tech.biz
To select a source, press the encoder shortly. The name of the current source will
start flashing on the display. Rotate the encoder until the desired source is displayed.
Then, press the encoder again to confirm: the new source will be selected.
Should the user change his/her mind and keep the current source, it is sufficient to
push the button to the left of the front panel (Fig. 1, 1) or avoid doing anything else:
After a few seconds the YOUNG DSD will automatically return in its “idle” status without
changing the source setting.
7.5. Menu Navigation
The YOUNG DSD allows for configuring various parameters, some of which (the ones
less frequently changed) are grouped in a menu which can be navigated by both the
front panel’s controls and the dedicated keys on the remote control.
To access the menu, keep the encoder pressed for at least two seconds or push the
“MENU” key on the remote control.
It is possible to scroll the various menu items with successive short pushes of the
encoder or with the “arrow up” and “arrow down” keys on the remote control.
Once the desired menu item is displayed, it is possible to choose the desired value
amongst the allowed values rotating the encoder or using the “arrow left” and “arrow
right” keys on the remote control.
The new value can therefore be confirmed with a new short push of the encoder or
by pushing the “OK” key on the remote control.