Magnum Dynalab MD-806T - Manual (Page 20)

- 20 -
IMAGE/FUNCTIONS OF RF-20 REMOTE
To use the remote control for your MD 806 you must first turn the unit ON with the
main power switch on the front of the unit. Next put the remote into its proper
mode to communicate with the Internet MediaTuner. Push the button next to MD
806 . Your remote is now in the proper operating mode.
1. ON BUTTON- Turns the touch screen on
2. OFF BUTTON-Turns the touch screen off , when not using the unit turn off the
main power with the power switch on the front off the unit.
GUIDE –allows access to all modes
3. INFO – Display’s additional information about the station and song
4. DIRECTIONAL PAD – Use this to navigate through the menu’s of your MD 806
Wi Fi Tuner (up/down/forward/back)
5. STORING PRESETS.
FM /DAB
Tune to the station: for preset positions from 1-5 push on the number you
wish to store the station at , the unit will tell you that the station has been stored
For positions from 6-10 you must push the large right arrow button under the
directional pad and the corresponding number 1-5, 1 being position 6 and 5
being position 10. To recall the station just push the number 1-5 or the large
right arrow button and the number 1-5
6. navigating in each mode:
Once you have chosen the mode the directional pad and the select button will
give you access to all the functions.