Magnum Dynalab MD-806T - Manual (Page 6)

- 6 -
SETTING UP THE MD Internet
Media Tuner
1. Position the tuner away from any
spot which may have extremes in
temperatures.
2. Place the tuner on a very rigid
surface capable of holding 75
pounds (34 KG).
3. It is important that the tuner is not
covered and it is not installed in a
closed area where there is little air
circulation. Ensure at least 2” of
clearance on the left and right of
the device, and 5” of clearance
above the unit to allow for proper
ventilation.
4. Connect the tuner to your
preamplifier or integrated amplifier
using a set of cables consistent
with the caliber of your system.
Select the input you chose on your
preamplifier/Integrated. Note: Be
sure that the preamplifier volume is
set to zero.
5. If hardwiring your Wi Fi Tuner Plus,
connect the Ethernet cable to the
Ethernet port, and the FM antenna
cable to the RF input, on the back
of the unit.
6. Unwrap the EIA AC cord and plug
the EIA end into the rear socket
marked
Power Input . Plug the other
end of the AC cord into a
120/220/230/240 volt
continuous AC power supply. Be
sure that the voltage marked on
the rear of the unit is the same as
the AC source that you are using.
7. Press the power button on the
front panel of the unit to the ON
position, you can touch the screen
with the styles provided , do not
use a sharp point to touch the
screen as it may damage the
surface. The screen will turn on
displaying the Magnum Dynalab
Logo as the MD 806 is warming
up.
The unit will then display the different
modes that are available to you, push
the logo of the mode you wish to
operate in.
Go to the settings mode and follow the
instructions on page 11
** CHECK TO MAKE SURE THE UNIT
IS SET UP FOR THE PROPER VOLTAGE
**
(Check for unit’s voltage marked on
rear panel) then plug the tuner’s AC
power cord into an AC power source.
Be sure to use a continuous power
source so as to allow the stand-by
mode feature to function properly.
The tuner’s audio output is muted in
the stand-by mode.