Magnum Dynalab MD-209 - Manual (Page 10)

- 10 -
RC4 REMOTE CONTROL
Unpacking the Remote:
• Remove the remote from its plastic bag, and install the 2 “AA” batteries provided
• Test the remote to make sure that all functions are operating correctly.
FUNCTIONS OF THE RC4 REMOTE
1. POWER MAIN: Power ON & OFF
2. TUNER REMOTE ON/OFF: This will power up the IR remote stage of the analog
tuner section. If this is ON, the tuner can only be adjusted using the remote, and
not manually. Similarly, if this feature is OFF, the tuner can only be adjusted
manually (using the tuning dial on the faceplate), and not with the remote.
3. TUNE UP/TUNE DOWN: Changes the FM frequency when using the FM tuner as
a source. Hold either the “TUNE UP” or “TUNE DOWN” button until you reach the
desired station. The longer you hold the button the faster the frequency changes.
To FINE TUNE, press either button shortly until your center tune meter is
centered.
4. PRESETS: Your precision remote gives you the ability to store up to 20 preset
stations. To program a preset station, first tune to the desired station and then
push “STORE”. Then select the preset memory position you want to store this
station in by selecting two digits. For Presets 1-9 you must select 01-09 and for
10+ directly enter the number. To recall these presets you must push “PRESET”
and then enter the two-digit preset you wish to recall.
5. VOLUME UP/VOLUME DOWN: Increase or reduces the volume level of the
preamplifier section of the MD 209 Hybrid Audio Receiver.
6. INPUT: Adjusts the selected source received by the preamplifier section of the
receiver (i.e. Tuner, CD, Aux 1). Push “Input” and then the corresponding
number key for the input you want. The TUNER input is input “9”, while the USB
input is input “8”. Note: There is a 10 second delay when switching inputs.
7. AUDIO MUTE: Mutes the amplifier section of the receiver.