Cyclades PC400 - Manual (Page 24)

24 Chapter 4 Board and System Configuration
Parameter Description Value for T1
line Value for E1
line
rx_sensitivity Sensitivity for reception. shaul shaul
companding_mode There are two options each for T1 and E1 lines. Ask
the service provider.
ulaw alaw
signaling_type Applies when CAS signaling mode is used. Ask the
service provider. loops r2digital
signaling_tone Applies when CAS signaling mode is used. Ask the
service provider. mfr1 mfr2c
country Choose your country (cas only). usa brazil
interfn_1_begin Logical link parameters
connection_type Whether the interface will be used for dial-in, dial-out
or both. both both
phone_num Phone number assigned to channel, if any. none 301
dsp_profile_id Number that identifies the profile, defined elsewhere
(or default) 1 1
interfn_1_end End of logical link parameters
•••
interf1_end End of first interface parameters
interf2_begin Second interface parameters
•••
interf2_end End of second interface parameters
dsps_auto_restart The number of times the DSP should try to re-load
its configuration if requested. 0 0
FIGURE 4.8 RAS DIAL-IN APPLICATION PARAMETERS (CONT.)