Outdoor Great Room Gas Grill LG36i - Manual (Page 15)

The Outdoor Greatroom Company • Legacy Gas Grill • Rev. E
15
Step 10. Assemble Side Tables
1. Parts Needed: Two side tables (left and right), two con-
diment trays, two handles, eight Philips head mounting
screws, six grilling tool hooks, (from parts Carton E),
Philips head screwdriver (not supplied).
2. Lay a side table upside down on a flat work surface.
Turn a condiment tray upside down and align the two
mounting holes with holes on the front face of the side
table. Run two screws through the table into the thread-
ed holes in the tray and tighten the screws with a Phil-
ips head screw driver. Repeat this procedure with the
second side table.
3. Slide three cooking tool hooks onto one side handle
with the open ends of the hooks facing down toward
the work surface. Align the handle with the two holes
on the side bend of the side table. Run two screws
through the table into the threaded holes in the handle
and tighten the screws with a Philips head screwdriver.
Repeat this procedure with the second side table. See
Figure 17.
Figure 17
Condiment Tray
Step 11. Install Side Tables
1. Parts/Items Needed: Two side table assemblies (from
Step 10), eight Philips head mounting screws, (from
parts Carton E), and Philips head screwdriver (not sup-
plied).
2. Position the left side table assembly against the top left
outside cart cabinet. Align the four mounting holes (two
each front and rear). Insert a Philips head mounting
screw into each threaded hole and tighten screws with
a Philips head screwdriver. Repeat this procedure with
the right side table assembly. See Figure 18.
Figure 18
Side Table
Handle
Hooks (Open ends down)