Outdoor Great Room Gas Grill LG36i - Manual (Page 19)

The Outdoor Greatroom Company • Legacy Gas Grill • Rev. E
19
Cleaning and Maintenance Instructions
As with all appliances, proper care and maintenance will keep
this grill in top operating condition and prolong its life. By fol-
lowing these cleaning procedures on a timely basis, the grill
will stay clean and work properly with minimum effort.
Cleaning The Cooking Surfaces
Before initial use and periodically, wash the cooking grids
in a soap and warm water solution. Use a wash cloth or
vegetable brush to clean the cooking grids.
CAUTION: Never try to clean the cooking grids until they
are cool to the touch.
Cleaning The Grease Drawer
To reduce the chance of fire, the Grease Drawer should
be visually inspected before each grill use. Remove any
grease and wash grease drawer with a mild soap and warm
water solution.
Cleaning The Burner Tubes and Burner Ports
NOTE: It is not necessary to remove the burner
when cleaning the burner tubes and ports.
To reduce the chance of “FLASH-BACK” follow the proce-
dure below at least once a month in late summer or early
fall when spiders are most active or when the grill has not
been used for a period of time.
1. Turn all burner valves to the full OFF position.
2. Turn the LPG cylinder valve (clockwise) to the full OFF
position.
3. Detach the regulator assembly from the LPG cylinder
by turning the Quick Coupling Nut counterclockwise.
4. Remove the cooking grids and searing plates.
5. Remove vaporizer plate.
Regardless of which burner cleaning procedure is used, we
recommend you also complete the following steps to help
prolong burner life.
1. Clean rear burner ports from area below searing plate.
2. Clean front burner ports from area underneath by re-
moving vaporizer plate.
3. Use a wire brush to clean the entire outer surface of
burner until free of food residue and dirt.
4. Clean any clogged ports with a stiff wire, such as an
open paper clip.
5. Inspect burner for damage (cracks or holes) and if such
damage is found, order and install a new burner. After
installation, check to insure that the gas valve orifice is
WARNING
Explosion Risk
Fire Risk
• Check to ensure the orifice is inside the burner
tube before using the gas grill.
• If the burner tube does not fit over the valve orifice,
lighting the burner may cause explosion and/or fire.
Keep surface of even heat vaporizer plate clean
1. Remove cooking grids.
2. Use a putty knife to scrape area clean.
3. Make sure perforations are free of any obstructions.
Checking Burner Flame Patterns
For proper operation the burner flame characteristics should
be steady, not lifting or floating. See Figure 24.
Figure 24
correctly placed inside the end of the burner tube. Also
check the position of the spark electrode. See Figure 23.
Figure 23
Burner Tube
Orifice