Filtering a video phones report – Cisco UNIFIED OPERATIONS MANAGER OL-19470-01 User Manual
Page 40
13-40
User Guide for Cisco Unified Operations Manager
OL-19470-01
Chapter 13 Generating Audio Phone and Video Phone Reports
Using Video Phones Reports
For more information, see the following topic:
•
Troubleshooting Tips for Audio Phones and Applications Reports and Video Phones Reports,
page 13-19
Filtering a Video Phones Report
From a Video Phones report, click the Filter button when present. A filter dialog box opens.
Note
Filtering is performed using:
•
An implicit “or” within each field—If you enter more than one value in a field, phones that match
any value are included in the report.
•
An implicit “and” for all fields—If you enter values in more than one field, phones that match at
least one value from each field are included in the report after filtering.
Switch Address
IP address of the switch to which the video phone is connected.
Port
Switch port used by the video phone; for example, Fa0/12.
Port Status
Status of the port used by the video phone: up or down.
VLAN Name
Name of the VLAN (user-defined name); for example, voice.
VLAN ID
ID of the VLAN for the video phone; for example, 100.
SRST Mode
One of the following:
•
yes—The phone is in SRST mode.
•
no—The phone is not in SRST mode.
•
?—The phone is suspected to be in SRST mode.
•
—(dash)—The phone is not an SRST phone.
SRST Router
One of the following:
•
IP address of the router that the phone is using for SRST.
•
—(dash).
Serial No.
IP phone serial number.
Note
This information is obtained by phone polling. See
.
Application ID
Identifier of the firmware running on the phone.
Note
This information is obtained by phone polling. See
.
Load ID
Identifier of the factory-installed load running on the phone.
Note
This information is obtained by phone polling. See
.
Launch button
Click and select a menu item to configure tests for the video phones
selected on this report.
Table 13-10
Video Phone Reports (continued)
Columns and Buttons
Description/Action