CREATIVE PC-DVD 5x Drive Dxr2 - Manual (Page 14)

Getting Acquainted with PC-DVD Encore 2
Rear Panel
Pull the ejected
tray out gently.
Avoid using
excessive force to
pull out the tray as
this may damage
your drive
Master Slave
(default)
Master/Slave jumper
sets the PC-DVD drive as
master or
slave when you connect it to another
PC-DVD or CD-ROM drive.
Note: Cable Select is reserved and
must not be used.
Power In connector
connects an electrical power cable
from your PC power supply to the
drive.
Enhanced IDE Data connector
transfers data between the PC-DVD drive and
devices, such as your computer’s hard disk and
motherboard, when connected by an IDE data cable. CD Audio connector
sends audio from the PC-DVD drive through
the Dxr2 card to the audio card when
connected by a CD audio cable.
Digital Audio connector
connects to a digital audio tape (DAT) or
professional audio system for digital
recording.
Note: This connector follows the EBU-
IEC958 standard set by the European
Broadcast Union (EBU).
To open the disc tray manually:
Turn off the power to your
computer before inserting the
paper clip into the Eject hole.
Dvd-fm.book Page 2 Thursday, December 17, 1998 9:44 AM