CREATIVE PC-DVD 5x Drive Dxr2 - Manual (Page 19)

Installing PC-DVD Encore 7
English
Step 3: Install the
Drive in Your
Computer 1. Insert the PC-DVD drive into the drive bay
as shown.
2. Connect a PC power cable to the PC-DVD
drive. The computer’s power supply is
usually located in a rear corner; several
power cables extend from the box with
connectors available for internal devices.
Power cable
Power In
connector
You may want to connect the
cables as described below before
you insert the drive into the bay.
Then, feed the cables through the
bay as you insert the drive.
Set the Master/Slave jumpers to
Master as shown in the figure on
page 2, unless you know that you
will be connecting to the Primary
IDE connector with the hard disk
drive.
Dvd-fm.book Page 7 Thursday, December 17, 1998 9:44 AM