Classe Audio CDP-502 - Manual (Page 18)

18
7 Classé CAN-Bus Control Ports
Th
ese RJ-45 connectors are provided for control and communication
applications using Classé Audio’s implementation of the Controller Area
Network (CAN) Bus specifi cation.
8 RS-232 Control Port
Th
is port has two purposes:
• downloading new operating software into your player (should
new features ever be added, for example)
• external control of your preamplifi er by systems such as
i-Command ™ , AMX ® and Crestron ™
For more information, please contact your dealer and ask about home
automation systems.
9 AC Mains Power Switch
Th
e main power switch for the CDP-502 is located at the right side of the
rear panel. Th e player should be in standby mode before being switched off .
Switching the unit on puts it in standby mode.
Danger! Potentially dangerous voltages and current capabilities exist
within your disc player, even when disconnected from AC
mains. Do not attempt to open any portion of the player’s
cabinet. There are no user-serviceable parts inside your
disc player. All service of this product must be referred to a
qualified authorized Classé dealer or distributor.
10 AC Mains Input
An IEC standard power cord (supplied) is used with the CDP-502. Plug
the cord into the IEC outlet provided, and the other end into a suitable
wall outlet.
Th e AC inlet assembly includes a built-in fuse for the protection of the
unit in case of major AC mains problems and/or component failure.
If your CDP-502 ever behaves as though it were not connected to the AC
mains (meaning, it seems completely “dead”), remove the AC cord from
the unit, and open the fuse holder immediately above the AC cord inlet.
If the fuse is blown, take your CDP-502 to your qualifi ed Classé dealer
immediately.
Caution: There are no user-serviceable parts inside the CDP-502. Do
not attempt to diagnose the problem yourself.