Classe Audio CDP-502 - Manual (Page 39)

39
distance Th e distance setting adjusts the speaker distance settings manually as you might
have done with a surround processor.
Simply measure the distance with a tape measure or equivalent, and enter the
distance into the menu. Th
e CDP-502 will automatically convert this distance
to the appropriate delay, to ensure that you hear the sound from each speaker
when you are supposed to hear it, despite the varying distances usually involved.
(Th
ese delays are applied to the multichannel analog output only. Your surround
processor will handle the signals sent out the digital output.)
Note that the distance delay is applied to all audio outputs of the CDP-502,
including those contained on the HDMI digital interface.
level trims Th e level trims adjustments adjust the speakers’ levels manually as you might
have done with other surround processors. A noise sequencer is available to
provide a reference signal for adjustment purposes. Holding a dB SPL meter at
the listening position, at arm’s length, and pointing straight up at the ceiling,
adjust the level of each speaker in turn until it reads 75 dB SPL when the meter
is set to “C” weighting and Slow response.
Note that the level trims are applicable only to the analog outputs of the
CDP-502. As with your other source components, the CDP-502’s digital
outputs are forwarded to the associated preamplifi er/processor unchanged.
Th
is allows your preamplifi er/processor to be accurately calibrated once for all
incoming source signals.
Th e Dolby Late Night button engages and disengages the Late Night mode for
Dolby Digital soundtracks, allowing you to enjoy movies with less chance of
disturbing others.
video setup Taking full advantage of the CDP-502’s extensive video capabilities is simple.
Th ree menus will take care of everything.
video standard Th ese settings are usually preset for the geographic market in which you
purchase the CDP-502. However, should you need to change the output of the
CDP-502 to conform with a diff erent standard, your choices are:
• NTSC/PAL/native — either choose the broadcast standard for your area,
or set the CDP-502 to play the disc in its native format. Th is last option
requires that you have a suitable multistandard display that can handle
both NTSC and PAL.
• IRE 7.5 or 0 — the “video setup” in North America assumes that black
is reproduced at a video level of 7.5 IRE units, while most of the rest of
the world assumes that video black is represented by a video level of 0 IRE
units. Th
e CDP-502 can operate either way; you should pick the standard
common to your area for compatibility with the rest of your video sources.
• Extended Black — the CDP-502 off ers a choice between PC (extended
black) and CE black levels. Use Extended Black to pass “blacker than
black” video when connected to a Consumer Electronic display (not a PC
monitor.)
NOTE: Extended Black is available by selecting RGB 4:4:4 in the color
space page. Th is feature is only applicable via HDMI output.