Curtis TC924 - Manual (Page 10)

7. Install the HANDSET BATTERY PACK by
plugging it into the BATTERY
CONNECTOR inside the BATTERY
COMPARTMENT.
8. Place the BATTERY PACK inside the
BATTERY COMPARTMENT.
9. S l i d e t h e H A N D S E T B A T T E R Y
COMPARTMENT COVER firmly into
place in its closed position.
10. IMPORTANT: Before initial use, charge
the HANDSET for 12 hours. Place the
HANDSET on the BASE UNIT with
TELEPHONE KEYPAD face up, and
make sure that the CHARGE LED
indicator on the BASE UNIT lights up
and a “beep” tone is heard.
11. TONE/PULSE Select Switch:
A. If your home is equipped with a tone dialing system, set the TONE/PULSE
Select Switch to the TONE position.
B. If you have a rotary dialing system, set the TONE/PULSE Select Switch
to the PULSE position.
C. If you are not sure which system you have, set the TONE/PULSE Select
Switch to the TONE position. Press the Talk button on the HANDSET
and make a call. If the call connects, leave the switch as is; otherwise set
to the PULSE position.
12. Set the date and time on the HANDSET. (See page 23 for details.)
Belt Clip Installation
With the back of the HANDSET facing up,
insert one side of the BELT CLIP HOOK into
the matching slot at the top side of the
HANDSET. Press down on the opposite side
of the BELT CLIP until the other hook locks
into the slot on the side of the HANDSET.
CAUTION: The cordless telephone operates at a frequency that cause interference
to nearby TVs and VCRs; the base phone should not be placed near, or on top of a
TV or VCR. If interference is experienced, moving the cordless telephone farther
away from the TV or VCR will often reduce or eliminate the interference.
Getting Started
9
BATTERY PACK
BATTERY
COMPARTMENT
COVER
HE
AD
SE
T
BELT CLIP
HOOK