Vernier EasyData Guidebook - Manual (Page 20)

EasyData Guidebook 19
Collecting Data Manually (Single Point)
In Single Point mode, EasyData samples readings from the sensor for a 10
second period. When sampling is finished, the mean reading is calculated and
displayed. Each time a reading is collected, it is stored in memory for future use. If
you wish to clear previously collected data, select New from the File menu.
To collect data in Single Point mode
This example uses an EasyTemp and a TI-84 Plus calculator. Your screens will
vary depending on which sensor and data-collection device is attached.
1. Turn the calculator on, and start the EasyData app.
After a few seconds, the EasyData main screen is
displayed. The screen shows the current EasyData
mode and the current sensor reading.
2. From the EasyData main screen, select , and
then select Single Point.
3. Select to begin collecting data. EasyData collects
data for 10 seconds.
When data collection has finished, the averaged
reading is displayed.
4. If you wish to keep the reading and prepare EasyData
to take another, select
.
If you are finished and no other readings are to be
taken, select
.
5. To collect another reading, repeat Steps 3 and 4.