Software programming – Talkaphone ETP-402V Dual Button Emergency / Information Phone User Manual
Page 13
Software Programming
*65*
Cancels *64* command (default)
*70*
Disable automatic playback of the recorded message when a call is
answered, but do not delete the message
*71*
Enable automatic playback of the recorded message when a call is
answered (default)
*72*
Set message length to 5 seconds
*73*
Set message length to 10 seconds (default)
*74*
Set message length to 16 seconds
*75*
Allow the performance of Operation Codes *25*, *26*, *28*, and
*29* WITHOUT the Guard Access Code—See Auxiliary Device
Codes, page 10
*76*
REQUIRES the Guard Access Code to perform of Operation Codes
*25*, *26*, *28*, and *29*—See Auxiliary Device Codes, page 10
(default)
*77*
Disable automatic playback of the recorded message when a call is
answered and delete the message
*78*
Automatically turns on unit speaker & microphone every time you
call in to the unit
*79*
Cancels the *78* command (default)
*80* …[up to 18 digits]*
Programs the primary number called by Button #2
*81* …[up to 18 digits]*
Programs the secondary number called by Button #2
*84*
Activate recorded message when pressing Button #1 only (default)
*85*
Activate recorded message when pressing Button #2 only
*86*
Activate recorded message when pressing either Button #1 or #2
*87*
Sets Button #1 to activate Output #1 when pushed
*88*
Cancels *87* command (default)
*90*
Sets Button #2 to activate Output #1 when pushed
*91*
Cancels *90* command (default)
*92*
Sets Button #2 to activate Output #2 when pushed
*93*
Cancels *92* command (default)
*100*
0.5 second hang-up on busy or no answer (default for ETP-100
Series)
*101*
1
2.25 second hang-up on busy or no answer (default for ETP-400
Series)
*102*
51ms on/off dialing speed (default)
*103*
1
102ms on/off dialing speed
*104*
Transmit phone ID when phone answers call (default)
*105*
1
Suppress transmission of phone ID when phone answers call
#
• If used during a call, immediately disconnect call
• If used in a dial string, pause for four (4) seconds
6
1
Activates Auxiliary output #1 for 1 second
1
Not available on ETP-100 Series phones.