Software programming – Talkaphone ETP-402V Dual Button Emergency / Information Phone User Manual
Page 9
Software Programming
G. Intelli-Voice Option Codes
The "V" option allows you to program a voice message that will play automatically
when the guard answers the call. This message serves to identify the unit to the
guard station.
Command Function
*72*
Set the message length to 5 seconds
*73*
Set the message length to 10 seconds (default)
*74*
Set the message length to 16 seconds
*58*
Record the identification message after the beep and until the next beep
*59*
Playback the recorded message
*77*
Disable the automatic playback of the recorded message when a call is
answered and delete the message
*70*
Disable automatic playback of the recorded message when a call is
answered, but do not delete the message
*71*
Enable the automatic playback of the recorded message when a call is
answered (default)
*84*
Activate the message when pressing Button #1 only (default)
*85*
Activate the message when pressing Button #2 only
*86*
Activate the message when pressing either Button #1 or Button #2
H. Phone ID Codes
An important function of the phone is the ability to identify itself and its location to the
guard station, because the caller may be unable to do so. There are several
methods of accomplishing this task. One method is to have the phone transmit a
DTMF identification number when the call is answered.
• This DTMF transmission can be received by the Talk-A-Phone EB-200 Base
Station or by the Talk-A-Lert™ software (model ETP-TAL).
• The code is 6 digits long and any leading digits you do not enter will automatically
be 0. For example, if you enter a code of 23, it will be transmitted as 000023.
• You should use codes that are logical for your environment. For example, if you
want to identify the third elevator in the second elevator bank of the fifth building
on campus, you might use the code 050203.
Command Function
*12* …[six digits]*
Program the phone Identification number
*49*
Suppress automatic transmission of the phone ID (default)
*50*
Automatically transmit the phone ID when guard station answers a call
1
*104*
Transmit the phone ID when the phone answers a call
2
(default)
*105*
Suppress transmission of the phone ID when the phone answers a call
3
1
Required for use with Talk-A-Lert base-station software or EB-200 base station
2
Required for use with Talk-A-Lert polling software
3
Not available for ETP-100 Series phones