Talkaphone ETP-402V Dual Button Emergency / Information Phone - Manual (Page 18)

10-Number Autodialing Keypads
 



  







V. 10-Number Autodialing Keypads (ETP-400KE, ETP-400KSE, ETP-402KE,
ETP-402KSE)
A. Programming
To program the autodialing phone numbers for buttons 0-9, use the following
codes:
*13* …[up to 11 digits]* Programs the phone number called by the RED button (if available)
*23* …[up to 11 digits]* Programs the phone number called by keypad button #0
*80* …[up to 11 digits]* Programs the phone number called by keypad button #1
*81* …[up to 11 digits]* Programs the phone number called by keypad button #2
*89* …[up to 11 digits]* Programs the phone number called by keypad button #3
*90* …[up to 11 digits]* Programs the phone number called by keypad button #4
*91* …[up to 11 digits]* Programs the phone number called by keypad button #5
*92* …[up to 11 digits]* Programs the phone number called by keypad button #6
*93* …[up to 11 digits]* Programs the phone number called by keypad button #7
*94* …[up to 11 digits]* Programs the phone number called by keypad button #8
*95* …[up to 11 digits]* Programs the phone number called by keypad button #9
To set the dialing speed, use the following codes:
*96* 51ms on/off dialing speed (default)
*97* 102ms on/off dialing speed
For other programming information, such as how to program for operation on a
PBX, timing codes, etc., see Section III (page 6).
B. Operation
If the phone has a red button, pressing it will automatically dial the pre-programmed
number and operate the auxiliary outputs if it is programmed to do so. On these
units, there is no backup number for the top button.
When the black call button is pushed, the user will hear a dial tone and can then
use buttons 0-9 on the-keypad to dial one of ten pre-programmed numbers. When
the called party answers, simply speak hands-free. When the called party hangs-
up the unit will automatically disconnect. To hang up the phone while it is active,
simply press the black button a second time. When the call is in progress, the
keypad is active for use with message systems, to enter a mailbox number, etc.
The black call button is used to take the phone off hook before placing a call with the keypad.
This button cannot be programmed with an autodial phone number and it cannot be used to
automatically activate an auxiliary output.