Talkaphone ETP-MTE-WP Wireless ECO TOWER with Pole - Manual (Page 15)

Solar Kit Installation Instructions
Copyright 2013 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com. Page 15 of 25
All specifications are subject to change without notice. Talk-A-Phone is a registered trademark of Talk-A-Phone Co. All rights reserved.
V. Mechanical Installation
1. Install the LED light board above the phone opening. To install the polycarbonate light cover that
protects the LED light assembly from the inside, peel the protective film off the light cover and fit it onto
the studs inside the tower. Slide the LED board over the studs with the LEDs facing down. The built-in
spacers will keep the LEDs from resting on the acrylic window. Tighten down using the enclosed #6
nuts. Be careful not to over-tighten to avoid cracking the circuit board.
2. If using an ETP-CI cellular device for wireless communication, install the antenna (using the respective
installation instructions) on the enclosure mount for the ETP-MTE-WP or the pole mount for the ETP-
MT/R OP SOLAR by uninstalling the hole-plug at the top of the mount. Run the power cable for the solar
panel through the liquid tight cord grip on the side of the pole.
3. For ETP-MTE-WP (Refer to Figure 25),
a. Align the pole base to the center hole on top of the enclosure mount with a gasket in between.
Rotate the pole along the vertical axis to minimize the cable travel distance from the PV module
junction box and cord grip on the pole. Fasten the pole to the enclosure mount using the hex bolts
and nylon washers on the outer end and a washer and nut on the inside.
Figure 25. Exploded view of ETP-MTE-WP configuration