Talkaphone ETP-MTE-WP Wireless ECO TOWER with Pole - Manual (Page 3)

Solar Kit Installation Instructions
Copyright 2013 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com. Page 3 of 25
All specifications are subject to change without notice. Talk-A-Phone is a registered trademark of Talk-A-Phone Co. All rights reserved.
III. Tower Enclosure Installation
1. Remove the tower’s rear bottom access panel by removing tamper-proof screws.
2. Install one 3/4” leveling nut and one washer on each anchor bolt 2 ½” - 3 ½” above grade and verify that
nuts are level (0° pitch) as shown in Figure 1.
Figure 1 . Tower Enclosure Installation
3. Install the tower onto the leveling bolts with the emergency phone opening oriented in the direction
desired. Install the second set of nuts and washers. Tighten the upper fastening nuts; the bottom set is
only for leveling.
IV. Solar Panel Installation
1. Lay the solar panel face down on a protected flat surface.
2. Place the mounting rails on the back of the panel so the lip of the rail containing the panel mounting
slots/holes are facing the center of the panel as shown in Figure 2. Align one end of the rails to be
approximately flush with the bottom edge of the panel.
Figure 2. Mounting rails placed on rear surface of solar panel
3. Secure the mounting rails with a 1/4 - 20 x 3/4” bolt, flat washer, lock washer and hex nut in each of the
panel mounting holes (4 per panel) as shown in the Figure 3. Tighten the bolts to 7 ft-lbs.