Warpia SWP120A Rev B Installation Manual & Troubleshooting Guide - Manual (Page 24)

24
this information, and in such cases the resolution settings available in the
Screen Resolution Window will be limited, to avoid damage to the monitor.
„ The external monitor connected to the StreamHD™ is incorrectly identified as a
"Non-PNP monitor" in the Windows® Device Manager.
y The monitor name displayed in the Windows® Device Manager is
controlled by Windows®.This designation will not affect the functionality of
the device.
„ The computer's built-in display does not turn off when the external monitor
connected to the StreamHD™ is set as the primary monitor.
y On some systems, the StreamHD™ video adapter cannot control the
internal display.
„
Mirror mode is not available (grayed out).
y Mirror mode is not available if the external monitor connected to the
StreamHD™ is set as the primary display.
y
To enable Mirror mode, set the computer's built-in display as the primary
display in the Windows Display Properties dialog box.
„
Scalable Link Interface (SLI) mode is not available
y
This product does not support SLI mode when more than two graphics
cards are installed in the connected computer. In such cases, SLI mode is
disabled
„ In Windows Display Properties, I cannot move the external monitor icon where I
want relative to the icon of the computer's built-in display
y Try dragging the computer's built-in display icon instead, relative to the
external monitor icon.
„ I cannot drag windows from my primary display to the external monitor onnected
to the StreamHD
y Follow these steps to fix the problem:
1) Open the Windows® Display Properties dialog box and position the
monitor icons on the Settings tab to match the physical arrangement of
your monitors.
2) Make sure the "Extend to" setting matches the physical arrangement of
your monitors.