Warpia SWP120A Installation Manual & Troubleshooting Guide - Manual (Page 35)

StreamHD Installation Guide
35
3. Check the option This is my main monitor.
(in Windows XP - Use this device as the primary monitor ).
4. Click OK to save the new settings.
Note:
On some PCs it is necessary to disable the main display (uncheck
the box marked Extend the desktop onto this monitor for the main
display) as part of the same settings change.
The Base Adapter remains the primary one if the PC enters
Hibernate or Suspend mode or is rebooted. If the Base Adapter is
detached, the main display becomes the primary display again.
Supported Resolutions
Problem/Question:
I have a Full HD TV but I can’t set the screen resolution on it to 1920 x 1080
which is the native resolution of this TV.
Answer:
The maximum screen resolution supported by the product is 1080p (1920 x 1080).
However in mirror mode you are limited by the maximum resolution of your PC.
Therefore you need to change the mode to extend mode as described in
Configuring the Display .
The StreamHD adapter does not turn on
Problem/Question:
The StreamHD adapter does not turn on.
Symptom:
No picture is displayed on the wirelessly connected screen/TV.
Solution:
Make sure the power cord is properly connected to the base. Verify the TV is set
to the correct input (i.e. HDMI1). This is done using the remote control of the TV.
Additionally, follow the steps on the quick start guide for HW and SW installation
that can be found in the autorun (in the CD) and check the section
Configuring
the Display .