Audio does not switch to tv or screen, Setting audio output device, Setting audio – Warpia SWP120A Installation Manual & Troubleshooting Guide User Manual
Page 74: Output device
StreamHD Installation Guide
74
Audio does not switch to TV or screen
Problem/Question:
Audio remains on the PC sound device and does not switch to the TV or Screen.
Symptom:
I have started watching a movie or clip on the internet and then connected the
Wireless USB kit laptop dongle. The picture is showing on my TV but the sound
did not switch to the TV.
Solution:
Restart the player or refresh the web page after connecting the dongle, to allow
the default audio device to switch to the USB audio device. This doesn’t always
happen automatically after the player or webpage was already activated.
You can also refer to the Audio setting section
Setting Audio Output Device
The PC audio output device should set itself automatically to the connected
Wireless USB Adapter C- Media audio device. If it doesn't, you can select the
correct Audio Playback device from the drop down dialog as follows:
In Windows XP:
1. Right click the Volume icon
in the System Tray and select Adjust Volume
Properties.
2. In the Sounds and Audio Devices Properties screen, select the Audio tab.
3. In the Sound Playback > Default Device drop-down box, select the USB
PnP Sound Device.
4. Click OK to save the new setting.