C. Crane PR-D8 - Manual (Page 11)

11
a. Setting Radio Alarm Time
1. The radio alarm can be set in both ways (radio on or off).
2. Press and release radio alarm button , the radio will show
radio alarm symbol.
3. Press and hold button for more than 2 seconds followed by
a beep.
4. Display hour will flash, using tuning up/down button to select hour
then press button again to confirm hour setting.
5. Follow same procedures of setting hour to set required minute.
Press button again to complete the alarm time setting.
6. During the radio alarm time setting, the display will also flash the
last tuned radio frequency. Press tuning up/down button to
select required wake up radio station or simply press preset
station button to select wave up station.
7. Press button again to complete radio alarm setting.
8. Press and hold radio alarm button for 2 seconds to cancel
the radio alarm. Display radio alarm symbol will disappear
followed with a beep.
Note:
If the new radio alarm station is not selected. It will select the last
programmed alarm station.