C. Crane PR-D8 - Manual (Page 12)

12
GB
Setting the HWS (Humane Wake System)
Buzzer Alarm
A beep will active when selecting the HWS buzzer alarm. The alarm
beep will increase in volume every 15 seconds for one minute
followed by one minute silence before repeating the cycle.
The HWS alarm will sound for an hour until turning off by pressing
the power button. Press the power button while the alarm is
activated and will cancel the alarm for 24 hours.
1. The HWS buzzer alarm can be set in both ways (radio on or off).
2. Press and release HWS buzzer button , the symbol will show
on the display.
3. Press and hold button for more than 2 seconds followed by
a beep, display hour digit will flash.
4. Pressing tuning up/down to select required alarm hour and then
by pressing button again, the minute digit will flash.
5. Pressing tuning up/down button to select required alarm minute,
press the button again to complete alarm setting. Display will
appear when buzzer alarm has been set.
6. Press and hold the buzzer alarm button for more than
2 seconds followed by a beep to switch the alarm to on or off.